Fireplace gas pilot light

Advertisement

November 5th,2019

GV60 Remote Electronic Ignition and Control System

qualified service technician to inspect the control and or gas appliance and to replace any part of the control system and any gas control which has been under water. GV60 Remote Electronic Ignition and Control System 1 of 5 For your safety, read the user instructions before attempting to light the appliance.

November 5th,2019

INSTALLING AND OPERATING YOUR MONTIGO GAS …

LIGHTING PILOT AND MAIN BURNER The gas control valve is located behind the grille in the centre of the fireplace (see Figure 5 below). Before lighting the pilot, make sure that the gas line is connected and the gas shut-off valve is turned to the ON position. To light the …

November 5th,2019

TROUBLESHOOTING GUIDE FOR FIRE PITS AND FIRE TABLES

TROUBLESHOOTING GUIDE FOR FIRE PITS AND FIRE TABLES PROBLEM POSSIBLE SOLUTION R9T12FIRETRB Page 1 of 2 Rev. A 112712 Pilot will not light. 1. Is the Gas valve open at the gas tank? If not, open the gas valve fully

November 5th,2019

FOR INSTALLERS AND SERVICE TECHNI CIANS ONLY GAS …

B) PIEZO IGNITOR OK BUT PILOT WILL STILL NOT LIGHT Make sure all gas lines have been connected with no leaks. Make sure that the gas is “ON” (NG) Natural gas and (LP) Propane tanks are full. Make sure the appliance service valve is in the “ON” position. SEE PAGE 4 FIGURE 3. Test to make sure there is no air in the gas line. SEE PAGE 4 ...

Advertisement