Cleaning hardiplank siding

Cladding - James Hardie

HardiePanel cladding can be installed on facades or soffits, with or without insulation. General. Ventilated facade system Air Inlets Air Outlets. Note: Cladding with HardiePanel boards must always be carried out as a ventilated facade . with minimum 20 mm distance between the cladding and the rear lining (insulation material).

November 16th,2019

HardiePanel Installation Guide - James Hardie

Installing wet siding will result in shrinkage at butt joints. James Hardie isn’t responsible for damage caused by improper ... When cleaning up dust and debris, ne Ver dry sweep as it may excite silica dust particles into the user’s breathing area. Instead, damp debris down with a fine mist to suppress dust during sweeping, or use a HePa ...

November 16th,2019

Installation Guide - James Hardie

4 | Installation Guide | 5 General Overview HardiePlank® cladding is an 8mm thick weatherboard plank, to be used as external or internal cladding for both new build and renovation projects. To complement the product, both fibre cement and metal trim profiles are available

November 16th,2019

TECHNICAL BULLE TIN Cleaning and Maintenance #20

If cleaning panel, direction of the siding is up and down. Do not push soft brush or wet cloth too hard against product surface. Do not allow the soap and mildew cleaner to dry on the siding (continually rinse the area until all of the cleaner has washed off of the siding). Any areas that have been missed may show up when the siding has dried.

November 16th,2019

MATERIAL SAFETY DATA SHEET

Cladding, HardiPlank® Rough-Cut Cladding, HardiPlank® Rusticated Cladding, HardiPlank® Shingled Siding cladding, ... Good housekeeping practices are necessary for cleaning up areas where leaks or spills have occurred, dust has accumulated, including leaks and …

November 16th,2019

HardiePlank Cladding Installation Guide - Squaredeal

This spacing gives a 10 mm drip edge at the lower edge of the siding. Fix the siding to the vertical timber battens with one nail or screw on every batten. The centre line of the nail or screw should be 20-25mm below the top edge of the siding. When fixing the ends of the siding ensure the fixing is placed at 15 mm from the end. 6.3.3.

November 16th,2019

The Facts on Efflorescence - CertainTeed

If efflorescence occurs, it can be remedied with the techniques previously described. It’s also good to know efflorescence does not harm fiber cement siding structurally, nor is the siding hurt by proper surface cleaning. Properly installed and maintained, fiber …

November 16th,2019

Finishing James Hardie TECHNICAL BULLETIN Siding Products ...

Siding Products (S-100) ... James Hardie does not recommend these methods of cleaning. Low pressure water spray or a medium bristle (nonmetal) brush is more suitable for cleaning fiber cement products. Acid washing can damage the fiber cement surface and is not recommended. For care & maintenance instructions for ColorPlus and primed products ...

November 16th,2019

Cladding - James Hardie

HardiePanel cladding can be installed on facades or soffits, with or without insulation. General. Ventilated facade system Air Inlets Air Outlets. Note: Cladding with HardiePanel boards must always be carried out as a ventilated facade . with minimum 20 mm distance between the cladding and the rear lining (insulation material).

November 16th,2019

Cleaning James Hardie TECHNICAL BULLETIN ColorPlus #20

If cleaning panel, direction of the siding is up and down. Do not push soft brush or wet cloth too hard against product surface. Do not allow the soap and mildew cleaner to dry on the siding (continually rinse the area until all of the cleaner has washed off of the siding). Any areas that have been missed may show up when the siding has dried.