Brass fitting sizes

1 Technical - Wade

All Sizes All Sizes 3/4 to 1 BRASS ‘N’ TYPE FERRULES ASSEMBLY INSTRUCTIONS There are several basic rules which should be observed An important feature of the Wade compression fitting when jointing tubes with Wade medium pressure brass compression fittings. A: Ensure that the tube is clean and cut square to the tube axis.

Advertisement

November 14th,2019

AUTOMOTIVE FITTINGS, HOSES, LINES & TUBING

There’s never been a more complete collection of automotive fittings assembled into one easy-to-use display. The new Edelmann Big Brass 405 display has 405 facings for the industry’s most complete selection. It features brake line fittings, grease fittings, hose fittings and air brake fittings from Edelmann’s line of over 1000 parts.

November 14th,2019

BRASS, COPPER, AND BRONZE DIMENSIONS, WEIGHTS, AND ...

brass, copper, and bronze dimensions, weights, and tolerances (extracted from copper & brass research association standards. tables correspond to the national bureau of standards simplified practice recommendations r217-46) extra strong standard pipe size in inches nominal dimensions in inches pounds per foot outside diameter inside diameter ...

November 14th,2019

1 Technical - Wade

All Sizes All Sizes 3/4 to 1 BRASS ‘N’ TYPE FERRULES ASSEMBLY INSTRUCTIONS There are several basic rules which should be observed An important feature of the Wade compression fitting when jointing tubes with Wade medium pressure brass compression fittings. A: Ensure that the tube is clean and cut square to the tube axis.

November 14th,2019

Fittings - parker.com

10-3 Parker Hannifi n Corporation Catalog PH001/NA Fittings 10 Brass Compression Series 68C - 164C - 169C L D C HEX M L D M N MALE CONNECTOR SERIES 68C Part No.

November 14th,2019

FITTING and TUBING - SMC Pneumatics

Cv for each fitting element needs to be: Cv syst 2 9 9 elements assumed all equal P (assumption 50% P valves 50% P tube etc) The SMC fittings are quoted with effective orifice of S in mm2. (18mm2 Cv1) Thus if system Cv required was 0.6 valve to be used has a Cv of 0.85 each fitting system element used will have a Cv of 0.6 2 9 2.55 Cv2.55 46mm2

November 14th,2019

brass compression fittings

fitting shoulder. 5. Assemble the nut to the body, hand tight. 6. Tighten the nut to the body using a wrench to the number of turns indicated in the table to the right. special requirements plastic tubing: For application with either nylon or polyethylene tubing, it is recommended that the standard brass ferrule be replaced with a delrin ferrule.

November 14th,2019

Identify a BSP thread size - Irrigation Warehouse

To identify exactly which fitting you have, measure across the thread where the red arrows are on the image below. Now refer to the “Actual Major Diameter” column on the chart and then look left to see the Metric and Imperial name of that size. Below is the chart of names and actual measured sizes …

November 14th,2019

STEEL & BRASS FITTINGS SIZE COMPARISON CHART

STEEL & BRASS FITTINGS SIZE COMPARISON CHART VOL20F25 Imperial has made a concerted effort to provide accurate information in its catalog and on its web site, however Imperial assumes no responsibility for the accuracy of the information. ... SAE 45° FlArE NoSE SIzES

Advertisement